Field Splice Kit Installation
Last updated: October 2022
This article outlines the process for installing the Field Splice Kit.
|A - Set of Splice Kit Shells||B - Wire Connector|
1. Strip and Connect Wires
Ensure that the wires are a compatible gauge and width.
Strip 3/16” of sheathing from each wire end, connect each wire to the Connector, and tighten with a small flat-head screwdriver.
2. Align Connector
Place the Wire Connector into one of the shells using the post found in the center as a guide. Channel the wires into the grooves on each side of the shell.
3. Seal Shut
Test wired connections before sealing. Align the top and bottom shells then press them together. Ensure all four clips are engaged and apply equal pressure.