Field Splice Kit Installation

Roles: Technicians
Last updated: October 2022

This article outlines the process for installing the Field Splice Kit

Package_Contents_FSP4.png

A - Set of Splice Kit Shells B - Wire Connector

Installation

1. Strip and Connect Wires

Ensure that the wires are a compatible gauge and width.

FSK_SSpec_Sheet_Page_01_FINAL_A.png

Strip 3/16” of sheathing from each wire end, connect each wire to the Connector, and tighten with a small flat-head screwdriver.

Wire_connector.png

2. Align Connector

Place the Wire Connector into one of the shells using the post found in the center as a guide.  Channel the wires into the grooves on each side of the shell.

Align_connector.svg

3. Seal Shut 

Test wired connections before sealing. Align the top and bottom shells then press them together. Ensure all four clips are engaged and apply equal pressure. 

Group_6.svg